15-17 September 2019
London Olympia, National Hall

Plasa 2019

Exhibitor Products

Hero Subpage

plasa

ART2020 T4 Dimmer

Avolites Ltd K50

The available modules are 12 x 16A RCBO dimmer, 12 x 16A RCBO distribution circuits or 12 x 16A RCBO contactor module to provide switchable mains to fixtures. The modules are freely interchangeable by the user.

The main input and the loop-out connectors are protected with an electronically adjustable MCB and RCB combination, allowing the breaker parameters to be controlled easily and comfortably from the dimmer user interface.

The breaker controls enable the user to coordinate MBC and RCB breakers in the larger system to assure isolation of faults, and prevent large scale outages during live events. 

The overcurrent range can be selected on both breaker combinations as 125, 160, 250 and 320A, and the RCB differential current from 30mA, 100mA, 300mA, 1A, 3A, 5A and 10A  as well as the RCB delay ranging from 20mS to 10 seconds in 10 steps.

The main and loop-out breaker electronic settings are a vital tool to assure compliance with new regulations for temporary electrical systems that are being enforced more and more.

The ART2020 is fitted with a comprehensive set of safety and reliability features which includes the ability to test the connected mains before the system energizes, over-voltage or a missing neutral connection will not allow the system to energize. The control system is supplied from all three phases at the same time.

Clear indication lights are provided for the mains input both on the front and near the mains input and loop-out connectors to show mains connection status and if the loop-out is energized.

The three phases and the neutral current are measured and displayed, as well as the individual main and loop-out phase and neutral currents. The system can also display Var and Powerfactor which are important variables when working with generators.

The differential (earth leakage) current for the main and loop-out connectors as well as the total differential current is displayed along with the headroom actually setting headroom.

The dimmer is fitted with a Wieland ST17 (2-pin) or ST18 (3-pin) patch system comprising of 120 circuit outlets and up to 20 multi circuit outlets like the 19-pin and 6 or 8 circuit Harting.

The patch is located on the top of the rack to ensure it is easily accessible. The layout is intuitive and flexible with four outlets for the first 12 circuits and two outlets for the remaining 36 circuits. Six single outlets for the fixed mains are provided. The patch has a switchable patch light to allow working in the dark.

The separately supplied ST17 patch leads are fitted with a custom Avolites clip to retain the patch leads in the patch during transport.   The high retention force of the ST18 patch does not require a clip.

The familiar load test facility is provided, which is battery operated, as well as the new load tester that can test a whole multi-core at once for connected load and earth faults. The tester is battery operated to allow testing before the mains connection has been provided, and is six and eight channel multi-pin outlet standards compatible.
The Dimmer modules have 'load check' indicators for each dimmable channel to give a positive indication that a load is present and the local test fader on each dimmer channel to ensure that you can easily check the connected load without having to use a console.

The multi-functional DMX distribution can act as a dual DMX splitter with four outlets for each of the two DMX-512 5-pin XLR inputs. The same splitter outlets can be driven from Art-net or sACN generating two independent universes.

The ART2020 system can be provided with data either though a single DMX-512 5 pin XLR connector or additionally with ethernet either using Art-net or sACN protocols. The two data inputs can be HTP merged splitter. The user can select to use one DMX-512 5-pin XLR input as an input to the dimmer, allowing for two DMX 5-pin inputs to be merged.

The Dimmer supports a full range of control features such as soft patch for each channel, simple start address for a universe, curve, pre-heat and proportional limit setting per channel.

A host of information and diagnostics tools are provided, like isolated level data for each data input, and LED indication that Art-net or sACN universe data is present for the two splitter universes. This all assists the user in the complex world of mains and data distribution.

The ART2020 is supplied in a custom flight-case with wheels on the back panel, and three lids with ergonomically placed handles. The rack has RGB LED strips incorporated to aid working safely in dark environments. The LEDs can be set to any of the nine colours and when the system requires user attention the LEDs can change in colour to clearly indicate which rack. The module RCBO breakers are discretely lit to allow the breaker state to be seen in the dark.

Loading
See you at next year's show!

See you at next year's show!

Register your interest

 

Exhibitors

189

Seminars

66

Speakers

88

Days

3

Our Sponsors


 

Audio

Audio

Audio

AV

AV

Lorem ipsum dolor sit amet, consectetuer adipiscing elit.

Lighting

Lighting

Lorem ipsum dolor sit amet, consectetuer adipiscing elit.

Stage Technology

Stage Technology

Lorem ipsum dolor sit amet, consectetuer adipiscing elit.

Rigging

Rigging

Lorem ipsum dolor sit amet, consectetuer adipiscing elit.

 

Testimonials

  • It was a really impressive show. Every time I looked there were lots of conversations going on around the show floor. I think every exhibitor should be happy. It was magic!
    Mick Hannaford
    Robe
  • We rate PLASA as one of the best shows in the world. We’ve had a really successful event, meeting our European clients and securing new overseas contacts as well as visitors from closer to home.
    Gary Fails
    City Theatrical
  • The show was incredibly busy, I didn’t have a moment of quiet time. I’ve seen more international visitors here this year which is great. I love it!
    Darren Beckley
    ETC Ltd
  • We’ve been exhibiting at PLASA for around 10 years and show both competing and complementary technologies, allowing our customers to see the differences between them. No one feels they’re getting the hard sell, it works very well.
    John Penn
    SSE Audio
  • We were delighted that 80% of our European distribution network came to the show, and we had visitors from Korea, Hong Kong and the US. The stand was really busy and we’ve thoroughly enjoyed the show.
    Matthew Lloyd
    GDS
  • This year’s PLASA show was one of the busiest ever, and in my opinion, it was also one of the best we’ve exhibited at. All in all, it was a very positive show for us and our suppliers.
    Jonathan Walters
    A.C. Entertainment Technologies
  • The show was genuinely good and there was a buzz. We certainly had a crowded stand and we hope the successful launching of new products brings the results we want. May PLASA continue for many more years.
    Cliff Dounting
    Chauvet
  • I am a big fan of PLASA London since the move and believe that the PLASA team have totally re-invigorated the show and established it as the product show in the UK, where the UK market turn to look at new products.
    Ben Noble
    Push the Button